Specifications

C-giant rel 3.07. Sales by Jemba, Sweden. Tel [phone]
C-giant Page 29
6. ERROR CODES AND TROUBLESHOOTING
On some occasions an error code may appear in the display. The following codes are
available:
Speed and distance indicate negative values
If the values indicate negative values when driving ahead the reason is that the yellow
wire is connected to a positive voltage. This is the case if a remote button is connected
to yellow wire and it is quite normal. As soon as the remote button is defined to its
desired functions the default function (reverse) is disabled and the minus sign
disappeare.
At speed C-giant stops counting for a while, shows ”C-rally” then works again
The most probable reason is that the pulse rate from the speed sensor is too high. As a
result the calibration value is over 100 000. The solution is to contact your dealer and
replace the sensor interface or reduce the pulse rate to less than 10 pulses per meter
(1600 per mile).
A less likely reason is a bad connection for the power supply (plus as well as minus).
Code Reason Action to be taken
.
Voltage from the fuel sender was Check connections for the black cable.
unchanged for two calibration The power supply must be ON to the
points during fuel calibration. fuel sender (Ignition key ON).
.
Probably a bad connection for Recalibrate distance by driving the
the power supply. calibrating distance.
.
You didn't increase the amount Input a higher value for fuel for each
of fuel between two calibration calibration point.
points
Polarity of yellow cable changed Check connection of yellow cable.
at a speed of at least 10 km/h. If it is connected to a remote control
it should be defined before you use it.
See page 25.
.
.
Probably a bad connection for Consult Jemba for service or run a
the power supply. free diagnostic program from Jemba