Installation manual

SYSTEM 238 Installation Manual
18
Command Location 2E: Audible/Visual Switches
Digit Position (1): Entry Pre-alarm Enable
0 = No
1 = Yes: sounds keypad buzzers during entry delay
Digit Position (2): Exit Pre-alarm Enable
0 = No
1 = Yes: sounds keypad buzzers during exit delay
Digit Position (3): Bell Reverse Operation
0 = No
1 = Yes: supplies bell voltage in non-alarm state; Bell requires external power supply
Digit Position (4): Ring Back
Digit Position (5): Disable Loop LEDs
0 = No
1 = Yes: turns off keypad zone LEDs after 5 minutes
Default Values
(1) (2) (3) (4) (5)
10 001
2E
Command Location 2F: Unit Control
Digit Position (1): Local System Only
Default Values
(1) (2) (3) (4)
00 11
2F
Digit Position (2): Enable Daily Dynamic Battery Test
Digit Position (3): Enable Four Minute Power-Up Delay
Digit Position (4): Enable Soft Zone Operation
0 = No
1 = Yes: allows use of Emergency, Fire, and Police keys
0 = No
1 = Yes: disables all communications except RPS
0 = No
1 = Yes: tests battery under load every 24 hours
0 = No
1 = Yes: suppress alarms on power-up for 4 minutes


0 = No
1 = Yes: Automatic Bell test after arming (and Exit Delay has expired) for local or non-supervised
accounts; follows closing report for supervised accounts; sounds bell for 2 seconds.
Command Locations 2E and 2F