Specifications

Appendix E Display Cluster Protocol 265
enableLayerCond Change the set of enabled layer conditions. While the layer conditions can be
specified as part of the load command, this separate command allows the
layer conditions to be changed without loading another show. The command
takes a single, mandatory <uint> parameter with the same interpretation as the
conditional layers parameter of the load command (see table on page 255).
setLogoString Display the string parameter next to the WATCHOUT logo, when shown on
screen. See example on page 259.
standBy Enter/exit standby mode. In standby, the display and sound is muted, or
media on standby layers – if any – is performed (see “Perform Normal/In
Standby” on page 104). This mode can be entered/exited smoothly, by spec-
ifying a fade rate.
standBy true 1000
Fade out sound and image over one second and enter standby mode. If any
standby layer is available, its media is performed instead.
getStatus Get the current status of the WATCHOUT cluster master.
getStatus
Reply "WO2Launch" false 0 true true false 122 true
Parameter Description
<bool> Enter standby if true, exit if false.
[<uint>] Fade rate, in milliseconds. Defaults to zero if not specified.