Installation Instructions

Regulatory & Warnings section of Ducati vehicle manual
Radio components Certifications
Radio equipment installed in
the vehicle
Frequency band
Max Transmission
Power
04610184, 04610196, 04610233
135 kHz
50.6 dBµV/m @10m
Radio equipment installed in
the vehicle
Manufacturers' addresses
04610184, 04610196, 04610233
C.O.B.O. Spa
Via Tito Speri, 10 - 25024 - Leno (BS) - Italy
FCC/ISED Certifications
The manufacturers of these radio equipment declare that devices comply with the FCC and ISED
regulations.
Type
FCC ID
IC ID
04610184, 04610196, 04610233
2AVOV-04610184
25864-04610184
HVIN: 04610184 - PMN: 04610184
HVIN: 04610196 - PMN: 04610184
HVIN: 04610233 - PMN: 04610184
To comply with FCC and ISED RF exposure compliance requirements, a separation distance of at least 20 cm
must be maintained between the antenna of these devices and all nearby persons.
FCC Certification
FCC CFR 47 Part 15, § 15.19, (a) (3) Compliance information
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC CFR 47 Part 15, §15.105 Compliance information
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
FCC CFR 47 Part 15, §15.21 Information to user
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.