User Manual

S-Hook
Hinge
Figure 1
Shutter Hardware
REQUIRED FOR INSTALLATION:
Electric drill, Phillips screwdriver, 1/8" drill bit
Kit contains (4) hinges, (2) S-hooks, (10) screws
STEP 1
Determine where hinges and S hook will be
installed. Hinges are typically installed near ends
of shutters. S-hooks are installed on the bottom
outer corner. See Figure 1. NOTE: that if placing
hinges over fasteners, be sure pilot holes don’t
interfere with the fasteners.
STEP 2
Using the marks on front of hinges as guides, drill
pilot holes through the hinge and shutter, using a
1/8" drill bit. The back of the S-hook has a fin, the
screw will be placed here. After the position of the
S hook is determined, drill through the fin and into
the bottom of the shutter using a 1/8" drill bit.
STEP 3
Securely attach hardware using screws
provided.
If screw head coating is scratched during
installation, touch-up with satin black paint.
NOTE: