Manual

Product: Adirondack Rocker (C04)

Your purchase and who is C. R. Plastic Products Inc?

Parts: You will need:

1. Seat (A) 1. Drill

2. Back (B)

3. Arm and Front Leg (C)(2)

4. 2 Small Triangle Blocks(D)

5. Bag of Screws 38 #8x 1 1/2" (D)

6. 2 Rocker Runners (Left and Right) (E)

7. Two Rear Legs (F)

Note: Assembly is best done with 2 people.

C. R. Plastic Products Inc. is an environmentally conscious Canadian company. Our "Generation Line" of recycled

furniture will give you years of comfort, style and maintenance free enjoyment. You will find your furniture to be

waterproof and durable. By choosing this product, you are saving generations of trees and are reducing the burden

on our landfill sites. Thank-you for purchasing from C. R. Plastic Products Inc.

Step 3: Line up the back of the Arm (C) to the back of Rear Leg (F) and fasten

together with a screw. Place a Small Triangle Block under the Arm (as shown left)

and make sure it is flush with the underside of the arm, and lined up to the pilot

hole in the Rear Leg. Secure it by placing a screw upwards into the arm, then

place a screw through the hole in the Rear Leg into the Arm.

Step 2: Stand up Rear Leg and Runner assembly and place the proper Arm (C) on

the assembly. Front Leg and Arm go to the side of the Runner that does not have

the support block. The Front Leg will line up to the line scribed on the top of the

runner.

2. #2 Robertson or

Phillips screw driver

Step 1: Place Rear Leg (F) onto the block side of Runner (E). Line up the Rear

Leg to the scribe mark on the Runner(E), and fasten together with one screw. The

countersink should face up so screw sits flush and the Rear Leg sits vertical as

pictured.

Proudly Made In CANADA

PAGE 1
Product: Adirondack Rocker (C04) Your purchase and who is C. R. Plastic Products Inc? C. R. Plastic Products Inc. is an environmentally conscious Canadian company. Our "Generation Line" of recycled furniture will give you years of comfort, style and maintenance free enjoyment. You will find your furniture to be waterproof and durable. By choosing this product, you are saving generations of trees and are reducing the burden on our landfill sites. Thank-you for purchasing from C. R. Plastic Products Inc.
PAGE 2
Step 4: Place a screw into the Front Leg by placing it in the bottom of the Runner. Repeat Steps 3 and 4 for the other Arm and Runner Assembly. Step 5: Lay one Arm and Runner assembly on the ground with the Arm facing down. Place the Seat (A) with the rear of the side supports under the Rear Leg (F) and the front of the Seat side on top of the Front Leg(C), and place 1 screw through the underside of the seat into the proper peck mark on the front leg.