C30 St. Tropez Lounge Chair C.R. Plastic Products Inc. 1 – 533 Romeo Street South Stratford Ontario N5A 4V3 Toll Free: 800-490-1283 Fax: 519-271-8544 www.crpproducts.
A. Seat Qty: 1 D. Back Qty: 1 B. Left Arm Qty: 1 C. Right Arm PARTS LIST: A - Seat B - Left Arm C - Right Arm D - Back HARDWARE LIST: 20 – 1½” Screws 4 – 2” Screws Note: Read these instructions carefully before assembling. Tools required: # 2 Phillips or #2 Robertson bit and power drill. Find a clean, smooth area on which to work, such as a carpet, in order to avoid scratching the plastic surfaces. Two people might be required for assembly.
Step 1: Set the Left Arm (B) flat on the floor Fig. 1. Line up seat (A) keeping bottom edge of seat flush with bottom edge of center rail of arm. Keep front edge of seat back 1/8” from front of leg, (detail X) and attach with 6 - 1½” screws. Figure 1 Required Seat (A) Left Arm (B) 1½” Screws Use 1½” Screws only in this step. Qty 1 1 6 X 1/8” Keep front edge of seat back 1/8” from the front of leg. Keep bottom edge of seat flush with center rail of arm.
Step 4: Flip assembled part of chair over on to Arm (C), keeping bottom edge of seat flush with bottom edge of center rail of arm. Keep front edge of seat back 1/8” from front of leg, (detail U) and attach with 5 - 1½” screws. Step 5: Line up back, (detail V and W). Insert 2 - 2” screws to attach the back to the curved arm rest, (detail W) keeping screw holes centered on arm. Step 6: Insert 4 - 1½” screws.