Specifications

the two captive screws located in the battery cover (do not fully remove these from the cover)

and remove the cover. Inside is the battery holder. Lift out the holder and detach the connector if

it is already fitted. Load it with the eight batteries ensuring that each battery is inserted the

correct way round, (direction of batteries alternating). Roll each individual battery to ensure it is

located correctly and making proper contact. Replace the connector making sure that it is firm

and well seated, and put the loaded holder into the housing. Fit the cover and tighten the two

captive screws finger tight.

Note: Zinc Carbon batteries should not be left in the detector for long periods where they could

leak, so remember to remove them at the end of a day's searching.

BATTERY CHECK

A battery condition indicator is provided on the detector. To do this for the first time prior to

reading the remainder of the operating instructions proceed as follows:-

A) Turn the FREQUENCY control to BATT. CHECK and turn the THRESHOLD control to

1. The meter will indicate in the green area if the batteries are good and in the left or

central position if the batteries need replacing or recharging.

B) Turn the THRESHOLD control to POWER OFF.

Rechargeable batteries will not read as high into the green as standard batteries even when fully

charged. They also give less indication of discharge on the meter during use.

Checking The Batteries

CS6Pi

BATT.

CHECK

CONTROLS AND WHAT THEY DO

The CS6Pi has been designed to offer simplicity of use with high, reliable performance.