User Manual

A
B
C
D
A= 2cm or 3cm material.
B= Caulking.
C= C-TECH-I sink.
D= Mounting clip.
Before you begin:
1. Verify that the hole is cut showing the desired overhang.
2. You will need glue and caulking to install this sink.
3. Make sure to inspect the sink and verify you have the right clips for the job.
Instructions:
1. Clean the bottom of the slab where the anchor bolt will go as to be free of any debris whatsover.
Surface must be dry and clean, it should also be rough so that the glue may bond well.
2. Position the sink in its desired location and mark it on the bottom, also mark the locations of all
anchors now (as suggested above). Depending on site conditions the amount and position of clips may vary.
You can install the anchors either face up or face down, face down is the easiest and fastest.
3. Mix enough glue for all clips, place a dab on the intended location and place the anchor on top of the glue, flatten
the excess glue flush with the the anchor plate, the plate should have about 1/16'' of glue on it. Let dry accordingly.
5. Place a small bead of caulking between the sink and the surface.
6. Install the sink in its desired location. insert clip into anchor, then the washer then the butterfly nut, tighten gently.
If the clip does not sit on the sink and surface properly you will need to bend it as shown on 2, so it may tighten.
7. Once you are content with the position of the sink tighten clips as needed.
8. Install self adhesive sound pads on each side of the bowls.
8. In an effort to minimize accidental future damages to the bottom of the sink by the homeowner please recommend
bottom strainer-grids.
You are done
Thank you for choosing a C-TECH-I product,if you have further questions please contact your dealer.
1= Anchor bolt.
2= Clip.
3= Washer.
4= Butterfly nut.
FOLLOW ALL LOCAL BUILDING AND SAFETY CODES IN YOUR AREA.
THE ABOVE IS ONLY A SUGGESTED METHOD TO BE PERFORMED
AT YOUR OWN RISK. REFER TO OSHA FOR PROPER SAFETY PRACTICES.
1
2
3
4
C-TECH-I UNDER-MOUNT FASTENING DETAIL