Manual

ManualsBrandsC2G ManualsTools29404 Multifunction Cable Meter

CABLETOOL

MULMUL

MUL

TIFUNCTION CABLE METERTIFUNCTION CABLE METER

TIFUNCTION CABLE METER

USER’S GUIDEUSER’S GUIDE

USER’S GUIDE

APPLICATIONS

Installation - Measure the length of a cable remaining on a spool or in a box prior

to pulling a new run.

Trouble Calls - Identify the type of fault in a cable (short or open) and the location

by measuring the distance to the fault.

Moves, Adds and Changes - Verify cable lengths are less than the maximum

100 meters allowed prior to connecting computers or network equipment.

Job Costing - Measure the actual length of cables being replaced or upgraded.

Cabling Management- Identify a wire pair on a punchdown block by locating the

transmitted tone.

WARRANTY

Psiber Data Systems Inc. warrants that the product shall be free from defects in parts or workmanship for a period of 12

months from the date of purchase if used in accordance with Psiber Data Systems Inc. operating specifications.

THIS IS THE ONLY WARRANTY MADE BY Psiber Data Systems Inc. AND IS EXPRESSLY MADE IN LIEU OF ALL

OTHER WARRANTIES EXPRESSED OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTIES OF

MERCHANTABILITY OR FITNESS FOR ANY PARTICULAR PURPOSE.

Should any parts or workmanship prove defective, Psiber Data Systems Inc. will repair or replace at Psiber Data Systems’

option, at no cost to the Buyer except for shipping costs from the Buyer’s location to Psiber Data Systems Inc. This is Buyer’s

SOLE AND EXCLUSIVE REMEDY under this Agreement. This warranty does not apply to products which have been subject to

neglect, accident or improper use, or to units which have been altered or repaired by other than an authorized repair facility.

Return of Equipment - To return a product to Psiber Data Systems Inc., first obtain a Return Authorization number from

our Customer Service by calling 619-287-9970. The RA# must be clearly marked on the shipping label, or the package will not be

accepted by Psiber Data Systems Inc. See sample label below.

To: Psiber Data Sytems Inc.

7075-K Mission Gorge Road

San Diego, CA 92120

RA# XXXXXXXX

P/N 1005-0500-0000 Rev. B

Summary of content (4 pages)

PAGE 1
APPLICATIONS Installation - Measure the length of a cable remaining on a spool or in a box prior to pulling a new run. Trouble Calls - Identify the type of fault in a cable (short or open) and the location by measuring the distance to the fault. Moves, Adds and Changes - Verify cable lengths are less than the maximum 100 meters allowed prior to connecting computers or network equipment. Job Costing - Measure the actual length of cables being replaced or upgraded.
PAGE 2
BOX CONTENTS The CableTool Multifunction Cable Meter electrically measures the length of a cable using Time Domain Reflectometry technology. The CableTool measurement begins by transmitting an electrical pulse into the connected cable. The electrical pulse travels along the cable until it hits a discontinuity (either a short or an open) and is then reflected back to the unit. The CableTool precisely measures the time between launching the pulse and recieving the reflected pulse.
PAGE 3
CABLE LIBRARY SETUP TheCableTool has one cable library for general electrical applications and one for CATV installers. Pressing the Up/Down cursor key scrolls between the two libraries. Pressing the Select function key makes that library of cable types available for all length measurements. POWER DOWN SETUP The CableTool will automatically turn off after the time selected in the Power Down Setup screen.
PAGE 4
TONE SCREEN Pressing the Tone function key in the Mode Screen presents the Tone Screen and the CableTool begins transmitting the user selected tone pattern and frequency (see Tone Setup). The CableTool provides four different tone patterns which can be changed by pressing the Up/Down cursor key. The tone frequency can be changed by pressing the Select function key to move the arrow to the Band field and then pressing the Up/Down cursor key to change the frequency band.