TruLink™ Video Signal Booster User Manual
Introduction Thank you for your purchase! With the TruLink™ UXGA Video Signal Booster you can overcome VGA length limitations without compromising signal quality. With built-in amplification and equalization, you can place the monitor up to 210 feet away from the video source. No software is required- installation is as simple as connecting your monitor to one end, your VGA cable to the source end, and connecting the included power adapter.
Installation 1. Turn off the computer and monitor 2. Connect the HD-15 cable from your monitor to the “video out” port of the booster 3. Connect the power adapter to the booster and then to a wall outlet. The power LED on the booster will light to indicate the booster is receiving power. 4. Turn on the computer and monitor Daisy-Chaining Two Boosters 1. Turn off the computer and monitor 2. Connect the HD-15 cable from your monitor to the “video out” port of the first booster 3.
Pin Out Pin # 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 Signal Red Video Green Video Blue Video ID2 Ground Analog Ground Analog Ground Analog Ground NC Ground ID0 ID1 Horizontal sync Vertical sync ID3 Optional Cables Cables To Go offers a wide variety of monitor cables. The chart below shows cables available for purchase on our website at www.cablestogo.com or through our reseller partners.