TruLink™ VGA Matrix Switch w/Audio Model: 39973 Model: 39974 Operation Manual Ver. 1.
Operation Manual TruLink™ VGA Matrix Switch w/Audio Model: 39973 (2x2 Port) 39974 (4x4 Port) Thank you for purchasing the VGA Matrix Switch w/Audio. We recommend that you read this manual thoroughly and retain for future reference. 39973 39974 Function: The TruLink™ VGA Matrix Switch with Audio allows you to route multiple PCs, and display the image on multiple monitors at a time. You can also have the image from one PC on multiple monitors.
Table of Contents Functions ……………………………….…………………………………………...ii Package Contents…………………….………………………………………….....ii Features......................................................................................................…...1 Connecting the VGA Matrix Switch...…….…….………………………………..1 Operating the VGA Matrix Switch..........……………………………………….2-3 Operating the VGA Matrix Switch with the remote control.................2 Operating the VGA Matrix Switch from the front panel.......................
Features: • Route multiple PC sources to multiple monitors and speakers • PC selection via push buttons or IR remote control • IR remote control allows you to switch outputs from up to 6 feet away • PC online status lights for indication of a connected PC • Enhance video signal enhancement allows monitor to be placed up to 164 feet away • Supports video resolutions up to 2048x1536 • Suitable for VGA, SVGA, XGA, SXGA, UXGA, and Multi-sync monitors Connecting the VGA Matrix Switch Examples in th
Diagram of connections: Back of 39973 Operating the VGA Matrix Switch Operating the VGA Matrix Switch with the remote control On the remote control, there are two groupings of controls. Your set of Monitor buttons initialize control for the VGA Matrix Switch. You cannot switch between your PCs until you hit one of the Monitor buttons. The PC buttons allow you to switch between your PCs.
PC 1 and PC 2 Buttons Monitor 1 and Monitor 2 Buttons Steps 1. If you would like to control Monitor 1, press the Monitor 1 button, and when you press it, you will hear a beep sound. 2. Press either the PC 1 button if you would like your first PC to show up on Monitor 1 or PC 2 if you want your second PC to show on Monitor 1. After you press either PC 1 or PC 2, you will hear another beep. 3. Repeat steps 1 and 2 to control the Monitor 2 display.
Troubleshooting: Problem Possible Solution 1. Press firmly on the connections to make sure they are snug. No Picture 2. Power down equipment and power back on. 3. Make sure the correct input is being used by looking at the green indicator lights on the switch. 1. Make sure the connections are snug. No Sound 2. Check the volume level on your PC and your PC speakers.
Cables To Go™ ONE YEAR WARRANTY At Cables To Go, we want you to be totally confident in your purchase. That is why we offer a one year warranty on this device. If you experience problems due to workmanship or material defect for the duration of this warranty, we will repair or replace this device. To request a Return Merchandise Authorization (RMA) number, contact customer service at 1-800-506-9606 or www.cablestogo.com.
Disclaimer Information in this document is subject to change without notice. The manufacturer does not make any representations or warranties (implied or otherwise) regarding the accuracy and completeness of this document and shall in no event be liable for any loss of profit or any other commercial damage, including but not limited to special, incidental, consequential, or other damages.
