User Manual

5. Depress the lever towards the tool body until they

are fully closed.

6. Open the lever to remove the compressed

connector assembly from the tool.

TOOL CARE: We advise periodic use of “3 in 1” oil

on the plunger and other moving parts.

To Adjust for PCT TRS and PPC EX Connectors

NOTE: Cobra models installed with a fixed

plunger tip (indicated by an .830 or .710 label)

are not adjustable.

Cobra tools with adjustable plunger tips are factory

adjusted to the universal .830 close dimension. To

change to the .710 dimension for connectors such as

PCT TRS and PPC EX, follow these easy steps:

1. Loosen the lock nut with a 3/8" open end wrench

and thread it forward to free the plunger tip.

2. Place the connector in-between the tip and dogs

as you normally would to compress the connector

and squeeze the handle. You will see that the

connector is not fully compressed. Using the same

connector, screw plunger tip out approximately 5

turns and close the tool again. This will compress

the connector a little more. Repeat this process

until the connecter is completely compressed and

the handle has a slight spring back feeling.

3. Thread the lock nut back up against the plunger

away from the connector.

4. Tighten the lock nut with a 3/8" open end wrench

to stop the tip from coming out of adjustment

Drop Tool Instrux 1.16 2/2/16 2:48 PM Page 9