User Manual

NOTE: You may hear the wrench “click” at this

time as it works to overcome the breakaway force

of the tightened connector. This is fine, however;

damage may occur with excessive force.

2. Once loosened, grasp the connector and unscrew

by hand.

Wing Ding Torque Wrenches

Color coded to match F-connector

ports to the appropriate cables

and ensuring that connectors are

tightened with the correct torque.

Each Wing Ding set comprises two parts: a ring that is

placed on the port, and a finger wrench of the same

color that is placed on the corresponding F-connector.

To Install Wing Ding Torque Wrenches

1. Slide the port ring over the threads of the port on

the box chassis all the way to the base of the port.

2. Install the F-connector part over the hex nut on

the connector. For best results, Install before the

connector and cable are attached, orienting the

hex-shaped opening toward the front of the

connector. This will secure the wrench in place.

3. Once the Wing Ding wrench, connector and cable

are assembled, use the wrench to finger-tighten

the F-connector onto the port. This will ensure the

correct tightness for the connector.

4. Repeat the above steps for each port, using

differently colored Wing Ding wrenches. This will

ensure that disconnected cables are reconnected

to the correct ports.

Drop Tool Instrux 1.16 2/2/16 2:49 PM Page 15