User Manual

Field Maintenance Kits for the Hex Crimp Tool (MK-1050)
are available from your distributor. They consist of
4 retaining pins, fasteners, U-shaped spring washers,
1 set of links, adjustment wheel and retaining rings.
17
Carpet Cutter and
Drill Guide
Cuts easily and safely through
carpet and pad, avoiding snags,
pulls, and the “snowball” effect.
7/16" x 8" drill bit available.
1. Position tool to cut carpet by placing tip of tool on
designated spot, apply pressure and twist in a back
and forth manner. The serrated tip of the carpet
cutter will make an almost instantaneous cut,
leaving a small circular incision with no ragged or
frayed edges.
2. Remove cutter. The carpet plug is retained in
the tool when the cutter is removed. The plug
will be pushed out when the drill bit is inserted.
Homeowners or maintenance personnel may store
the plug for subsequent, almost invisible
replacement if wiring is removed at some future
date. Wiring installers report customers are partic-
ularly enthusiastic about this feature.
3. To drill flooring, position the tool in the carpeting
hole, insert the bit and proceed to drill through the
floor. The drill bit will be guided by the tool, thus
preventing it from walking and preventing entan-
glement with loose threads.
CAUTION: AS A SAFETY PRECAUTION, ALWAYS
REPLACE PLASTIC CAP ON BLADE WHEN TOOL IS NOT IN USE.
Drop Tool Instrux 1.16 2/2/16 2:49 PM Page 17