User Manual

use in about one minute, the first red light on the
CHT will illuminate, followed a few seconds later by
the second red indicator light and finally the third
red indicator light as the tool warms to 190°F
(88°C). When the center light turns green, the tool
has reached the right level of heat and is safe and
ready to use.
2. Fully insert the prepared cable (stripped and with
braids folded back as you normally would) into the
open end of the CHT and wait at least 10 seconds
before removing cable.
3. Push connector on as usually done. The heated
cable jacket will help you achieve a perfect
connection with much less effort. You are now
ready to compress the connector and complete
the job. (For best results, always use Cable Prep
cable stripping and compression tools.)
4. The Heat Prep CHT will shut off automatically
within about 60 seconds and can be conveniently
stored in any standard tool pouch. Store and
charge the CHT at temperatures between 32°F
(0°C) and 80°F (27°C).
NOTE: The CHT will accept cables up to a
maximum outer diameter of 11.43mm, or .45"
TIP: After stripping and heating flooded cable,
remove residue from both tools using a cotton swab
and Cable Clear® cleaning solution.
TOOL CARE: Ensure that the tool is clean and
free of debris. Do not use oil on the tool as it may
damage the plastic.
Warranty: One year from date indicated on receipt or
invoice.