Specifications

VPM2 Operation Manual
6
To add a program to memory:
1. Press the Menu button.
2. Use the Step (Arrow) buttons to select
ADD/DELETE PROGRAMS.
3. Press the
Enter button.
4. Use the Step (Arrow) buttons to select
ADD PROGRAM.
5. Press the
Enter button.
6. Select a memory number slot to program using the
Step (Arrow) buttons or the number pad.
7. Press the
Enter button.
8. Use the alphanumeric keypad to enter the name of
the program (9 characters are available). Press the
Enter button after each letter to accept.
Note:
• Pressing the same alphanumeric keypad button
will scroll through the characters on that button.
• Pressing the Enter button without selecting
a character will move the cursor right.
• Use the Down Arrow key to move back
and erase a character.
9. Once all the characters have been entered press
the Enter button until the next screen is displayed.
10. PREMIX YES? will be displayed. If no premix is
desired press an Arrow button to change from YES
to NO and press the Enter button again. If a Premix
is desired press the Enter button and enter the
speed, time and direction as prompted.
11. PRE VACUUM? NO will be displayed. If Pre Vacuum
is desired press an Arrow button and the Enter
button then select the amount of time for Pre
Vacuum. If no Pre Vacuum is desired press the
Enter button again.
12. MIX SPEED? will be displayed. Use the number
pad to enter the desired Mix Speed (100 RPM –
500 RPM).
13. Press the Enter button.
14. Mix Time – using the alphanumeric keypad enter
a number between 1 and 255 seconds for the
amount of mix time needed.
15. Press the Enter button.
16. POST VACUUM? NO is displayed. Use the Arrow
keys to choose YES or NO. Mix cycle w/o POST
VAC beeps immediately after mixing is complete.
POST VAC allows for continued vac for allotted
time after mix is complete. Important for Phosphate
Investments and yes, if you did not program PST
VAC you could achieve it by ignoring the END
CYCLE tune for 10–15 seconds.
17. Press the Enter button.
18. If YES was selected in step 16, use the number
pad to enter the amount of time needed for
Post Vacuum (0 – 30 seconds).
19. Press the Enter button.
20. When the program is complete the Main Menu
will be displayed and another memory slot may
be selected for programming.
The addition of the program should be complete.
Press Enter button to select program to run.