User`s guide

Chapter 3: Installation
3-12 6H128-08 and 6H129-08 User’s Guide
a. Ensure that the power is turned on for the device at the other end
of the link.
b. Verify that the fiber strands between the applicable port on the
6H12X-08 and fiber optic device on the other end of the segment
are properly crossed over.
c. Make sure that the fiber connection meets dB loss specifications
as specified in the Cabletron Systems Cabling Guide.
d. See Section 5.19 to configure the port using Local Management.
If a link has not been established, see Chapter 4, Troubleshooting, before
contacting Cabletron Systems Global Call Center. Refer to Section 1.7 for
details.
3.5 COMPLETING THE INSTALLATION
After installing the 6H12X-08 and any optional Fast Ethernet Interface
Modules, and making the connections to the network, proceed as follows:
1. Secure any cables that were attached to the unit so that troubleshooting
and safety are not compromised.
2. The 6H12X-08 is now ready to be set up through Local Management.
Refer to Chapter 5, Local Management, for information on how to
access and use Local Management to configure the 6H12X-08 module
and 6C105 chassis.