Switch User Manual
EXAMPLE NETWORKS
40 CyberSWITCH
The WAN interface summary screen will then be displayed. If all of the configured information is
accurate, press <return> to save the information.
Finally, we will enter the interface information for the WAN (Direct Host) interface. Press 1 to add
another interface. This interface will be used for devices Jill Smith and Todd Jones. The interface
name is a symbolic name given to the interface. For the WAN (Direct Host) interface, you should
use a name that describes the Direct Host WAN. For this example, both Direct Host WAN sites are
located in Monterey, so we will enter Monterey for the interface Name.
You will also need to enter an MTU value. Press <return> to accept the default of 1500. If all of the
configured information is accurate, press <return> to save the information.
After all three interfaces have been configured, the following screen will be displayed:
We have now completed the IP information required for this example. Return to the Main Menu.
CONFIGURING THE SECURITY
This example has remote devices, and the device information for each of those devices must be
configured. Device security is used, and the remote devices are configured in the on-node
authentication database. Device security using a on-node authentication database are the default
values.
To begin the security configuration, press 3 at the Main CFGEDIT Menu to display the Security
Menu. The sections below provide instructions for configuring the needed security information.
C
ONFIGURING THE SECURITY LEVEL
To begin, press 1 at the Security Menu to display the Security Level Menu. To enable Device level
Security, press 2.
C
ONFIGURING THE SYSTEM OPTIONS AND INFORMATION
The default configuration for System Options is all security options enabled, which is acceptable
for this network. No System Information or Administration Sessions are required. Therefore, no
changes are necessary.
Current INTERFACE Configuration:
id Name Type IP address Mask
-- -------------- ---------------------- ------------- ---------------
1 sanfran LAN 128.1.1.1 255.255.0.0
2 sanjose WAN 192.1.1.1 255.255.255.0
3 monterey WAN (Direct Host) UnNumbered (128.1.1.1)
(1) Add, (2) Change, (3) Delete, (4) Display a INTERFACE or press <RET> for previous menu?