Switch User Manual

Workgroup Remote Access Switch 67
IP R OUTING N ETWORK WITH PPP D EVICES
Configure SITE1
The screen interaction will resemble the following:
After you have entered all of the information for the interface, a summary screen will be displayed.
If all of the configured information is accurate, follow the onscreen prompt to save the information.
1) LAN
2) WAN
3) WAN (Direct Host)
4) WAN (RLAN)
5) WAN (UnNumbered)
Select function from above or <RET> for previous menu: 1
INTERFACE NAME or <RET> to cancel? LAN1
Enter the IP Address in dotted decimal notation
or <RET> to cancel? 128.1.1.1
Enter the number of significant bits for the Subnet Mask
[default = 16]? <RET>
Enter the packet encapsulation type 1) for ETHERNET 2) for SNAP
[default = ETHERNET]? <RET>
Enter the MTU size in bytes [default = 1500]? <RET>
Transmit Broadcast Address:
1) 128.1.255.255
2) 128.1.0.0
3) 255.255.255.255
4) 0.0.0.0
5) Specify Explicitly
Enter a Transmit Broadcast Address [default = 1]: 1
RIP Send Control:
1) Do Not Send.
2) RIP Version 1.
3) RIP Version 1 Compatibility.
4) RIP Version 2.
Enter a RIP Send Control [default = 2]: <RET>
RIP Receive Control:
1) Do Not Receive.
2) RIP Version 1 Only.
3) RIP Version 2 Only.
4) RIP Version 1 or Version 2.
Enter a RIP Receive Control [default = 4]: <RET>
RIP Respond Control:
1) Do Not Respond.
2) RIP Version 1 Only.
3) RIP Version 2 Only.
4) RIP Version 1 or Version 2.
Enter a RIP Respond Control [default = 4]: <RET>
RIP Version 2 Authentication Control:
1) No Authentication.
2) Simple Password.
Enter a RIP Authentication Control [default = 1]: <RET>