VHSIM-G02 User’s Guide VHSIM-G02 1 9034001 2
Only qualified personnel should perform installation procedures. NOTICE Cabletron Systems reserves the right to make changes in specifications and other information contained in this document without prior notice. The reader should in all cases consult Cabletron Systems to determine whether any such changes have been made. The hardware, firmware, or software described in this manual is subject to change without notice.
Notice FCC NOTICE This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules.
Notice CABLETRON SYSTEMS, INC. PROGRAM LICENSE AGREEMENT IMPORTANT: THIS LICENSE APPLIES FOR USE OF PRODUCT IN THE FOLLOWING GEOGRAPHICAL REGIONS: CANADA MEXICO CENTRAL AMERICA SOUTH AMERICA BEFORE OPENING OR UTILIZING THE ENCLOSED PRODUCT, CAREFULLY READ THIS LICENSE AGREEMENT. This document is an agreement (“Agreement”) between You, the end user, and Cabletron Systems, Inc.
Notice If the Program is exported from the United States pursuant to the License Exception TSR under the U.S.
Notice CABLETRON SYSTEMS SALES AND SERVICE, INC. PROGRAM LICENSE AGREEMENT IMPORTANT: THIS LICENSE APPLIES FOR USE OF PRODUCT IN THE UNITED STATES OF AMERICA AND BY UNITED STATES OF AMERICA GOVERNMENT END USERS. BEFORE OPENING OR UTILIZING THE ENCLOSED PRODUCT, CAREFULLY READ THIS LICENSE AGREEMENT. This document is an agreement (“Agreement”) between You, the end user, and Cabletron Systems Sales and Service, Inc.
Notice If the Program is exported from the United States pursuant to the License Exception TSR under the U.S.
Notice CABLETRON SYSTEMS LIMITED PROGRAM LICENSE AGREEMENT IMPORTANT: THIS LICENSE APPLIES FOR THE USE OF THE PRODUCT IN THE FOLLOWING GEOGRAPHICAL REGIONS: EUROPE MIDDLE EAST AFRICA ASIA AUSTRALIA PACIFIC RIM BEFORE OPENING OR UTILIZING THE ENCLOSED PRODUCT, CAREFULLY READ THIS LICENSE AGREEMENT.
Notice If the Program is exported from the United States pursuant to the License Exception TSR under the U.S.
Notice DECLARATION OF CONFORMITY Application of Council Directive(s): Manufacturer’s Name: Manufacturer’s Address: European Representative Name: European Representative Address: Conformance to Directive(s)/Product Standards: Equipment Type/Environment: 89/336/EEC 73/23/EEC Cabletron Systems, Inc. 35 Industrial Way PO Box 5005 Rochester, NH 03867 Mr. J.
Notice x VHSIM-G02 User’s Guide
CONTENTS FIGURES ............................................................................................... xiii TABLES ................................................................................................. xiv CHAPTER 1 INTRODUCTION 1.1 Structure of this Guide................................................................. 1-2 1.2 Overview...................................................................................... 1-2 1.2.1 LANVIEW Diagnostic LEDs ................................
Contents xii VHSIM-G02 User’s Guide
FIGURES Figure 1-1 2-1 2-2 2-3 3-1 Page VHSIM-G02 .............................................................................. 1-1 Removing the VHSIM Coverplate from the Host Platform ....... 2-3 Installing the VHSIM-G02 in the Host Platform ........................ 2-4 Connecting a Twisted Pair Gigabit Ethernet Segment ............. 2-7 LANVIEW LEDs on the VHSIM-G02 ........................................
TABLES Table Page 3-1 A-1 A-2 A-3 A-4 VHSIM-G02 LED Functionality .................................................3-2 Physical Properties of the VHSIM-G02.................................... A-1 Environmental Requirements of the VHSIM-G02 .................... A-1 Regulatory Compliance of the VHSIM-G02 ............................. A-1 RJ45 Port Pin Assignments .....................................................
CHAPTER 1 INTRODUCTION Welcome to the Cabletron Systems VHSIM-G02 User’s Guide. This manual describes the VHSIM-G02 and provides information concerning features, installation, troubleshooting, information on Local Management, and specifications for the VHSIM-G02 (Very High Speed Interface Module). A general working knowledge of IEEE 802.3z (Gigabit Ethernet), IEEE 802.3ab (Gigabit Copper) and IEEE 802.
Chapter 1: Introduction 1.1 STRUCTURE OF THIS GUIDE Read through this manual completely to familiarize yourself with its content and to gain an understanding of the features and capabilities of the VHSIM-G02. The following list provides an overview of each section of this manual: Chapter 1, Introduction, outlines the contents of this manual, describes the VHSIM-G02 features and concludes with a web site address where related manuals can be obtained.
Document Conventions 1.2.2 Connectivity The VHSIM-G02 supports two modes of operation for the Gigabit interfaces. In one mode, the VHSIM-G02 supports one active and one redundant Gigabit Ethernet twisted pair port. In the other mode, both of the interfaces can be active at the same time, if the host platform has 16 or less fixed front panel ports. The VHSIM-G02 supports Gigabit Ethernet connections on the RJ45 ports using twisted pair. The VHSIM-G02 module supports the IEEE 802.
Chapter 1: Introduction 1.5 GETTING HELP For additional support related to this device or document, contact Cabletron Systems using one the following methods. World Wide Web http://www.cabletron.com/ Phone (603) 332-9400 Internet mail support@cabletron.com FTP ftp://ftp.cabletron.
CHAPTER 2 INSTALLATION Only qualified personnel should install or service this unit. To install the VHSIM-G02 you need the following items: • Phillips screwdriver • Antistatic wrist strap (shipped with the VHSIM-G02) • Standoff screws (shipped with the VHSIM-G02) NOTE 2.1 Before using the VHSIM-G02 you should be familiar with the IEEE 802.3z, IEEE 802.3ab, and IEEE 802.3x specification.
Chapter 2: Installation 2.2 INSTALLING THE VHSIM-G02 You can install a VHSIM-G02 in any Cabletron Systems device that supports VHSIM technology (e.g., 2E253-49R, 6H252-17). NOTE Refer to the release notes for the version of firmware running on the Cabletron Systems device to ensure that the VHSIM-G02 is supported. The following sections provide instructions for installing a VHSIM-G02 in an interface module or in a standalone device.
Installing the VHSIM-G02 4. Lay the module down with the internal components facing up. 5. Refer to Figure 2-1 and remove the two faceplate mounting screws and the VHSIM coverplate. Save the screws.
Chapter 2: Installation 6. Refer to Figure 2-2 and position the VHSIM-G02 behind the module faceplate, above the connectors. Standoff Screws Connectors (top view) Connectors Cutaway view of connectors VHSIM-G02 1 2 VH SIM -G 02 Standoff SP Connectors Standoff Faceplate Mounting Screws Host Platform 25491_36 Figure 2-2 Installing the VHSIM-G02 in the Host Platform 7. Align the VHSIM-G02 connectors with the VHSIM connectors on the module.
Installing the VHSIM-G02 8. Press down firmly on the VHSIM-G02 until the connectors slide all the way onto the pins. Ensure that the standoffs on the interface module align with the standoff screw holes on the VHSIM-G02. 9. Secure the VHSIM-G02 to the module faceplate using the mounting screws saved in step 5. 10. Secure the VHSIM-G02 to the module standoffs using the standoff screws shipped with the VHSIM-G02. 11. Reinstall the interface module in the chassis. 12.
Chapter 2: Installation 5. Refer back to Figure 2-1 and remove the two faceplate mounting screws and the VHSIM coverplate. Save the screws. 6. Refer back to Figure 2-2 and place the VHSIM-G02 module behind the standalone device faceplate. 7. Align the VHSIM-G02 connectors with the pins on the standalone device. ! CAUTION When inserting the VHSIM-G02 onto the device pins, ensure that the pins do not bend, as this can damage both the device and the VHSIM-G02. 8.
Network Connections 2.3 NETWORK CONNECTIONS The VHSIM-G02 has two RJ45 connectors for the Gigabit Ethernet connections, Port 1 and Port 2. The cable used for connections is 4-pair Category 5 Unshielded Twisted Pair, conforming to the IEEE 802.3ab specification. The maximum distance supported is 100 meters. Refer to Appendix A for the pin assignments for the RJ45 port.
Chapter 2: Installation 3. Verify that a link exists by checking that the port RCV (Receive) LED is ON (flashing amber, blinking green, or solid green). If the RCV LED is OFF and the XMT (Transmit) LED is not blinking amber, perform the following steps: a. Verify that the cabling being used is Category 5 UTP with an impedance between 85 and 111 ohms. To operate at 1 Gbps, category 5 cabling must be used. b.
CHAPTER 3 LANVIEW LEDs This chapter describes how to use the LANVIEW LEDs to monitor the VHSIM-G02 status and diagnose VHSIM-G02 problems. Figure 3-1 shows the location of the VHSIM-G02 LEDs. Refer to Table 3-1 for a description of the LEDs. Section 3.2 describes redundancy. 3.
Chapter 3: LANVIEW LEDs Table 3-1 LED Transmit Receive 3.2 VHSIM-G02 LED Functionality Color Definition Green (Flashing) Activity, port enabled. Amber (Blinking) Port in standby. Off No activity, port enabled or disabled. Red (Flashing) Transmit fault or error. Red Diagnostic failure. Green (Solid) Link, no activity. Port enabled. Green (Blinking) Link, port disabled. Amber (Flashing) Link, activity. Port enabled. Off No link, no activity. Port enabled or disabled.
CHAPTER 4 LOCAL MANAGEMENT This chapter provides information about using Local Management with the VHSIM-G02. The VHSIM-G02 is managed using the Local Management Ethernet screens for configuration and statistics on the host platform. NOTE 4.1 The host platform is the interface module or standalone device in which the VHSIM-G02 is installed.
Chapter 4: Local Management 4-2 VHSIM-G02 User’s Guide
APPENDIX A VHSIM-G02 SPECIFICATIONS This chapter lists the specifications and regulatory requirements for the VHSIM-G02. Cabletron Systems reserves the right to change these specifications at any time without notice. A.1 PHYSICAL AND ENVIRONMENTAL SPECIFICATIONS Table A-1 Physical Properties of the VHSIM-G02 Dimensions 3.18 H x 16.51 W x 29.21 D (cm) 1.25 H x 6.5 W x 11.5 D (in) Weight 0.34 kg (0.
Appendix A: VHSIM-G02 Specifications A.3 GIGABIT PORT PIN ASSIGNMENTS The following pin assignments are for the RJ45 Gigabit Ethernet ports on the VHSIM-G02. The twisted pair ports conform to the IEEE 802.3ab specification. The cables are 4-pair Category 5 UTP, up to 100 meters in length.
