- cabletron systems User's Guide SmartSwitch 2E43-51, 2E43-51R

Chapter 5: Local Management
5-28 2E43-51/2E43-51R User’s Guide
Figure 5-13 COM Port Warning Screen
3. Use the arrow keys to highlight YES. Press ENTER.
4. If you ENABLED the port, proceed to step 5. If you DISABLED the
port, use the arrow keys to highlight SAVE at the bottom of the screen,
then press ENTER.
5. When the message “SAVED OK” appears, the edits you made are
saved.
6. Use the arrows keys to highlight the Application field.
!
CAUTION
If the COM port is reconfigured without a valid IP address set
on the device, the message shown in Figure 5-13 displays.
Do not continue unless the outcome of the action is fully
understood.
!
CAUTION
Exiting without saving causes the message “NOT SAVED --
PRESS SAVE TO KEEP CHANGES” to appear. Exiting without
saving causes all edits to be lost.
WARNING
174252
THE COM PORT HAS BEEN RECONFIGURED AND THERE IS NO IP
ADDRESS SET FOR THIS DEVICE. YOU WILL NO LONGER BE ABLE
TO MANAGE THIS BOARD. DO YOU STILL WISH TO RECONFIGURE
THIS COM PORT?
YES
NO