Owner manual

Chapter 5: Local Management
5-54 2M46-04R/2M46-04RDC User’s Guide
The following definitions briefly explain each field of the Port Redirect
Function screen:
Source Port (Read-only)
Shows which ports are currently set as source ports.
Destination Port (Read-only)
Shows which ports are currently set as destination ports.
Remap Errors (Read-only)
Shows whether destination ports are receiving errored frames and valid
traffic (ON) or just valid traffic (OFF).
Source Port [ n ] (Selectable)
Allows a selected port [n] to be changed to a source port.
Destination Port [ n ] (Selectable)
Allows a selected port [n] to be changed to a destination port.
Errors (Toggle)
Allows the user to configure the source ports to send errored frames and
valid traffic to selected destination ports (ON), or to drop errored frames,
and send only valid traffic to the destination ports (OFF). The default
setting of this field is ON.
Status (Selectable)
Allows the addition or deletion of source and destination ports selected in
the Source Port [n] and Destination Port [n] fields.
5.16.1 Displaying the Source and Destination Entries
There can be more than one Port Redirect Function screen depending on
the number of port redirect entries. Each screen displays up to 10 port
redirect entries. If there is more than one screen of redirect entries, the
NEXT and/or PREVIOUS command is displayed at the bottom of the
screen, allowing the user to navigate to either the next or previous screen.