Owner manual

Management Terminal Setup
2M46-04R/2M46-04RDC User’s Guide 5-3
5.3 MANAGEMENT TERMINAL SETUP
Use one of the following systems to access Local Management:
• An IBM or compatible PC running a VT series emulation software
package
• A Digital Equipment Corporation VT100 type terminal
• A VT type terminal running emulation programs for the Digital
Equipment Corporation VT100 series
• A remote VT100 type terminal via a modem connection
• In-Band via a Telnet connection
5.3.1 Console Cable Connection
Use the Console Cable Kit provided with the 2M46-04R to attach the
management terminal to the 2M46-04R COM port as shown in
Figure 5-1.
Connect an IBM PC or compatible device, running the VT terminal
emulation, to the 2M46-04R as follows:
1. Connect the RJ45 connector at one end of the cable (supplied in the
kit) to the COM port on the 2M46-04R.
2. Plug the RJ45 connector at the other end of the cable into the
RJ45-to-DB9 adapter (supplied in the kit).
3. Connect the RJ45-to-DB9 adapter to the communications port on
the PC.
NOTE
If using a DEC VT style terminal for Local Management, use
the DB25 adapter for this device instead of the DB9 adapter.