Owner manual

SNMP Traps Screen

2M46-04R/2M46-04RDC User’s Guide 5-33

5.9.1 Conﬁguring the Trap Table

To conﬁgure the Trap table, proceed as follows:

1. Use the arrow keys to highlight the appropriate Trap Destination

field.

2. Enter the IP address of the workstation that is to receive traps. IP

address entries must follow the DDN format.

For example: 134.141.79.121

3. Press ENTER. If an invalid value is entered “INVALID IP

ENTERED” is displayed in the Event Message Line.

4. Use the arrow keys to highlight the Trap Community Name field.

Enter the community name.

5. Press ENTER.

6. Use the arrow keys to highlight the Enable Traps field. Press the

SPACE bar to choose either YES (send alarms from the 2M46-04R to

the workstation), or NO (prevent alarms from being sent).

7. Use the arrow keys to highlight the SAVE command and press

ENTER. The message “SAVED OK” displays on the screen.

8. To exit the screen, use the arrow keys to highlight RETURN and press

ENTER.

The designated workstations now receive traps from the 2M46-04R.

NOTE

Link traps may be disabled by using Network Tools. See

Section 5.22 for more details.