User`s guide

3-40
Configuring
Config on ATX #2
mirror remote 2 to 134.141.100.1
Mirror Filters with REMOTE Port Mirroring:
• Desired - to see packets from station A (on P2) only
• Implementation - add a PMEntry filter to port 2 on ATX #2 with
station A’s MAC address as the source address in the filter.
3.12 IPX ROUTING OVER SOURCE ROUTE COMMANDS
Command ipxroute is expanded with additional option sr to
support IPX SR on token ring and FDDI ports. Option
sr implies
on. The explorer type and cache aging time can be configured
using SNMP with the MIB variables. Refer to the ATX MIB
Reference Guide Addendum (902021) for the specific MIB
variables. The following is the LCM command format:
ipxroute [PORT-RANGE [{off | on | sr}]]
3.13 PING COMMANDS
The LCM command for ping is as follows:
ping [-rvsx] host_IP [data_size [count]]
-r = record route
-v = verbose
-s = send one packet per second continuously
-x = send packets continuously without delay
3.14 TRACEROUTE COMMANDS
The LCM command for trace route is as follows:
traceroute [-m max_ttl] [-q nqueries] [-w
wait] host_IP [data_size]