User`s guide

1-2
Introduction
• Chapter 2, Installing and Connecting to the Network ,
describes the ATX front panel, how to install the ATX, and how
to connect the Local Console Manager.
• Chapter 3, Configuring , provides instructions for configuring
bridging, and IP, IPX, and AppleTalk Phase II routing using the
Local Console Manager. It also provides the MIB variables for
configuring multicast storm protection and some common
variables you may want to change.
• Chapter 4, Monitoring and Managing the ATX , describes how
to monitor status and statistics. It also describes how to manage
modules and ports using the Local Console Manager.
• Chapter 5, Filters , provides instructions for adding, modifying,
and deleting filters using the Local Console Manager. It also
provides specific examples of how filters can be used.
• Chapter 6, Traps , describes the traps the ATX sends to an SNMP
manager.
• Chapter 7, Diagnostics and Troubleshooting , describes the ATX
diagnostics and provides information on troubleshooting
common problems.
• Chapter 8, Adding/Swapping Modules and Maintenance ,
provides instructions for adding or swapping a module. It also
describes how to change fuses and clean the fan filters.
• Appendix A, Technical Specifications , lists ATX specifications.
• Appendix B, Packet Translation Procedure , describes the
canonical format the ATX uses for translating packets.
• Appendix C, Null Modem Cable Pinouts , provides the cable
pinouts for a null modem cable.
• Appendix D, Glossary , provides a glossary of terms both
specific to the ATX and common to the internetworking field.