- Cabletron User's Guide SmartSwitch Interface Modules 6H258-17, 6H259-17

Using LANVIEW
4-4 Troubleshooting
TX Off Port enabled, and no
activity. Should flash green
every two seconds
indicating BPDUs being
sent if STA is enabled and
there is a valid link.
1. Ensure that the STA is enabled and
that there is valid link. describes how
to enable the STA.
2. Contact Cabletron Systems.
Green Flashing. Indicates activity.
Rate indicates data rate.
None.
Amber Blinking. Port in standby.
Port may be disabled due to
Spanning Tree.
1. Ensure that the port is not disabled.
Refer to your Local Management
User’s Guide for information on
enabling/disabling ports.
2. Contact Cabletron Systems.
Red Flashing. Indicates
collision rate.
None, unless there is a high rate of
activity. If so, check for network
configuration problems or a defective
device.
Solid. Diagnostic Failure. Contact Cabletron Systems.
Table 4-1 LANVIEW LEDs (Continued)
LED Color State Recommended Action