Installation guide

SPECTRUM
Installation Guide
Page 16
Document 0675
Determining and Changing Landscape Handles
This section contains the procedure for changing a SPECTRUM landscape
handle. You may need to complete this procedure if you are upgrading an
existing SpectroSERVER database and need to change its landscape handle
to meet SPECTRUM requirements
Determining the Current Landscape Handle
Procedure
1. Navigate to:
<$SPECROOT>/SS
2. Run the following command:
../SS-Tools/lh_set
Changing the Landscape Handle Of a SpectroSERVER Database With
Existing Models
Procedure
1. Navigate to:
<$SPECROOT>/SS
2. Run the following command:
../SS-Tools/dbpart1/converter <-ss or -ddm>
../SS-Tools/dbpart1/ConvTable <new landscape handle>
The above two lines are a single command, typed at the command
line.
Use the -ss or -ddm arguments to change landscape handles in only
the SpectroSERVER database or only the DDM database. If you do not
specify either one, both databases will be converted. Your new
landscape handle can be specified in either decimal or hexadecimal
format.
Several SPECTRUM resource files specify the landscape handle. You
must manually change each of these files to ensure that all
SPECTRUM applications continue to function. A mismatch of
landscape handles between resource files and what the
SpectroSERVER is actually using can cause problems with Archive
Manager, Data Export, and the Report Generator. After changing a
SpectroSERVER’s landscape handle, you must also change the
landscape handle in the following files:
<$SPECROOT>/app-defaults/SDE