Installation guide

SPECTRUM
Installation Guide
Page 34
Document 0675
3. [Windows NT only] On the Services tab, ensure that SNMP Service
is listed under Network Services; then click OK. If the SNMP
software is not listed, install it from the Windows NT disks.
4. Make sure that the user profile for the person logged on and running
SPECTRUM is configured to send e-mail using the supported service
provider if you plan to use e-mail for applications such as SPECTRUM
Enterprise Alarm Manager.
5. Set security as desired for the directory where you are installing
SPECTRUM. Any changes to the directory hierarchy security are
preserved by SPECTRUM if the settings are made prior to installation.
6. Restart your system.
User Auditing
If user auditing is enabled on Windows NT platforms, every action is
audited, resulting in many entries to the Windows EventLog. Aprisma
recommends that NT user auditing be disabled, as it will decrease
SPECTRUM system performance.
Converting Your File System to NTFS
SPECTRUM must be installed in an NTFS (versus FAT) partition. If your
hard drive is formatted as a FAT partition, you must to convert your
Windows file system to NTFS.
Procedure
1. Start Windows Explorer.
2. Select your hard drive.
3. Select File > Properties.
4. On the General tab of the Local Disk (X:) Properties window,
confirm whether the File system field displays NTFS or FAT.
If it displays FAT, you must convert your file system to NTFS by
running the CONVERT.EXE utility located, by default, in the
<drive letter>:\Winnt\system32 directory.
5. Navigate to:
\Winnt\system32
6. Run the conversion utility. For example, for a hard drive designated
C, enter the following command: