Installation guide

SPECTRUM
Installation Guide
Page 35
Document 0675
CONVERT C: /FS:NTFS
The conversion utility can be run without damaging or deleting
existing data. If the hard drive has already been converted, a
message to that effect display when you enter the command above.
7. Restart your workstation for the reformatting to take effect.
Stopping the Process Daemon (processd)
[Upgrades From 5.0.1 Only]
If you upgrading from SPECTRUM version 5.0.1, the SPECTRUM process
daemon, processd, must be shut down before you install the newer
version.
Procedure
1. Log in as Administrator.
2. Open a SpectroSHELL.
3. Navigate to:
<$SPECROOT>/SDPM
4. Run the following command:
./processd.sh stop
5. Processd automatically restarts when you restart the system after
installation. If you quit the installation before it is complete, you will
need to restart processd. To restart processd without restarting your
system, run the following command:
./processd.sh start
Uninstalling NuTCRACKER [Upgrades From 5.0.1 Only]
SPECTRUM no longer uses the NuTCRACKER product that automatically
installed with SPECTRUM 5.0.1. If you performed an upgrade on a Windows
workstation, you can save space and improve SPECTRUM performance by
removing NuTCRACKER; however, you should first make sure that no other
applications on your system will be affected by its removal.