Installation guide

SPECTRUM
Installation Guide
Page 53
Document 0675
The following sections provide more detailed instructions for using the
Installation Configuration screen:
Selecting an Installation Type
[page 53]
Selecting Location Configuration [page 54]
Installing Individual Components [page 54]
Installing All SPECTRUM Components on a Single Workstation [page 55]
Installing SpectroGRAPH Only [page 55]
Installing SpectroSERVER Only [page 55]
Resetting the Default Component Configuration Values [page 56]
Using the Command Buttons [page 56]
Selecting an Installation Type
Procedure
In the Installation Type Choices panel (see Figure 14 [page 52]
), do
one of the following:
• To install (and link) any or all of the SPECTRUM components, select
Install.
• To rebuild previously installed SpectroGRAPH and SpectroSERVER
executables and selectively link individual management modules, select
Re-link previously installed components.
Note: If you are installing for the first time, the relinking
option is grayed out.