Installation guide

SPECTRUM
Installation Guide
Page 54
Document 0675
Selecting Location Configuration
Procedure
Important: If you are doing an upgrade installation on either
Solaris or Windows, the owner of the target
directory must have a SPECTRUM user model in the
database being upgraded. Otherwise, the directory
owner will not be able to start SpectroGRAPH after
the installation is completed.
In the Location Configuration panel’s Target Ownership field (see
Figure 14 [page 52]
), do one of the following:
• For Solaris installations, this field is blank. Type the user name of the
owner of the target directory (the directory in which you are installing
SPECTRUM).
Note: Although you must log in as root to run the
installation, the owner of the target directory
should NOT be root.
• For Windows installations, this field shows the user name used to log
into the workstation. Type the user name of the owner of the target
directory (the directory in which you are installing SPECTRUM).
Installing Individual Components
Procedure
1. In the Component Configuration panel (see Figure 14 [page 52]
),
click Select Individual Components.
2. In the Component Selection screen (see Figure 15 [page 57]
),
select (or deselect) the individual components you want to install.
See Component Selection Screen
[page 57] for more information on
installing individual components.