Installation guide

SPECTRUM
Installation Guide
Page 58
Document 0675
The following sections provide more detailed information on the
Component Selection screen:
Components Available for Installation Table
[page 58]
Using the Selector Buttons [page 60]
Selection Filters [page 61]
Using the Command Buttons [page 62]
Components Available for Installation Table
The scrollable table at the top of the Component Selection screen (see
Figure 15 [page 57]
) identifies each of the components purchased, or
already installed on the target system. For each component listed, the
table provides the following information:
F (Fold/Unfold) Components that show a plus symbol (+) in this column
have sub-components that display (or unfold) by clicking the plus
symbol (+). Components showing a minus symbol (-) either have no
selectable sub-components or have already been unfolded, in which
case, clicking the symbol folds the sub-components back into the
original parent component.
Part Name This column displays the part name of the component. Click
any cell in this column to display the component’s description in the
Component Description panel. Only major components and
components that have no sub-components can be selected or
deselected by clicking the part name.
Status This column identifies the component as belonging to one of the
following categories based upon the component’s internal revision
(Irev) number:
• DIST (Distribution) - The component exists only on the CD and has
not yet been installed. For an initial installation, all components will
be listed as DIST.
• INST (Installed) - The component has already been installed and is
present on the system, but is not part of the new installation.
• SAME - The version number of the CD component is the same as
the version number of another copy of the same component
installed on the target system.
• DNGRD (Downgrade) - The version number of the CD component is
older than the version number of an installed copy of the same
component type and represents a downgrade.