Installation guide

SPECTRUM
Installation Guide
Page 61
Document 0675
Selection Filters
The Selection Filters dialog box (Figure 16) lets you apply special filters to
override certain normal installation constraints by using the (SAME),
(UPGRD), and (DNGRD) buttons. Click OK to confirm settings and return to
the Component Selection screen, or click Help for instructions for this
screen.
The (SAME), (UPGRD), and (DNGRD) buttons (see Figure 15 [page 57]
)
can be used in situations where SPECTRUM is already installed to allow
selection of installation components that are the same as, newer than, or
older than, their installed counterparts. The UPGRD button is always set to
ON by default, although there is nothing to upgrade in an initial
installation. In subsequent installations, however, you may want to select
components in all three categories.
Note: The selection filters are not needed for normal
installation, and Aprisma recommends that you not
use them unless you first consult your Aprisma
service representative.
Figure 16: Selection Filters