Installation guide

SPECTRUM
Installation Guide
Page 74
Document 0675
Starting SPECTRUM and
Postinstallation Configuration
This section explains how to start SPECTRUM after its
installation and describes required and optional
postinstallation configuration tasks.
In this section:
Starting SPECTRUM
[page 74]
Upgrading SPECTRUM Models and Model Types [page 74]
Configuring SPECTRUM CORBA Services [page 75]
Scheduler Requirements (Windows) [page 78]
Important Files Created During Installation [page 78]
Setting up Client Access [page 80]
Remote Display of SPECTRUM [page 80]
Starting SPECTRUM
The SPECTRUM documents Getting Started with SPECTRUM for
Administrators (9030985) and Control Panel User Guide (9035100) provide
detailed information on starting SPECTRUM. Before starting SPECTRUM,
however, back up your SpectroSERVER database if you have just installed
a new version of SPECTRUM over an earlier one (see When Installation Is
Complete [page 73]).
Important: Aprisma strongly recommends that SpectroGRAPH
and other SPECTRUM applications be started either
from the SPECTRUM Control Panel or the from
desktop. Starting SPECTRUM from the command
line is not recommended.
Upgrading SPECTRUM Models and Model Types
If you are upgrading SPECTRUM, your existing SpectroSERVER database
may contain models created from obsolete or unsupported model types
from the earlier SPECTRUM version. For instructions on converting and