Installation guide

SPECTRUM
Installation Guide
Page 91
Document 0675
Procedure
1. Start the SpectroSERVER.
2. Navigate to:
<$SPECROOT>/SS-Tools/Convert_to_SSX
3. Run the following command:
Convert_to_SSX.script <SpectroSERVER host> <landscape handle>
The -gnsnmpdev flag can be added to the end of this command to
convert both Gen9000 and GnSNMPDev models. Only models of 9x5xx
devices are converted; other Gen9000 and GnSNMPDev models are not
converted.
4. After the script runs, check the Conv_SSX_Log_<DATE>_<TIME> file to
see if all models converted.
If a model was not in contact when the script was running, it will not
be converted. Ensure that the devices are active on the system and
repeat step 3
and step 4 until you have confirmed that all models are
converted.
Troubleshooting
If Convert_to_SSX.script does not run:
1. Ensure that you are a valid SPECTRUM user.
2. Navigate to:
<$SPECROOT>/vnmsh
3. Run the following command:
./connect <SpectroSERVER host>
4. Run the following command:
./disconnect <SpectroSERVER host>
MT_del_50R1_script.pl
The MT_del_50R1_script.pl script uses the db_remove utility to delete
deprecated model types from the SpectroSERVER database, ensuring that
a user will not inadvertently create a new model based on a deprecated
model type.