Specifications

ATM Switched Virtual Channel Cross Connect Table View
Device Management Page 130 SmartSwitch 9000/9500 Series
Low IF
The value of this object is equal to the ifIndex
value of the ATM interface port for this SVCC
cross-connect. The term low implies that this
ATM interface has the numerically lower ifIndex
value than the other ATM interface identified in
the same atmSvcVcCrossConnectEntry.
Low VPI
The value of this object is equal to the VPI value
associated with the SVCC cross-connect at the
ATM interface that is identified by
atmSvcVcCrossConnectLowIfIndex. The VPI value
cannot exceed the number supported by High
VPI at the low ATM interface port.
Low VCI
The value of this object is equal to the VCI value
associated with the SVCC cross-connect at the
ATM interface that is identified by
atmSvcVcCrossConnectLowIfIndex. The VCI value
cannot exceed the number supported by High
VCI at the low ATM interface port.
High IF
The value of this object is equal to the ifIndex
value for the ATM interface port for this SVCC
cross-connect. The term high implies that this
ATM interface has the numerically higher ifIndex
value than the other ATM interface identified in
the same atmSvcVcCrossConnectEntry.
High VPI
The value of this object is equal to the VPI value
associated with the SVCC cross-connect at the
ATM interface that is identified by
atmSvcVcCrossConnectHighIfIndex. The VPI
value cannot exceed the number supported by the
atmInterfaceMaxVpiBits at the high ATM
interface port.
High VCI
The value of this object is equal to the VCI value
associated with the SVCC cross-connect at the
ATM interface that is identified by
atmSvcVcCrossConnectHighIfIndex. The VCI
value cannot exceed the number supported by the
atmInterfaceMaxVciBits at the high ATM interface
port.
Created Time
The value of the sysUpTime object at the time this
bi-directional SVCC cross-connect was created. If
the current state was entered prior to the last re-
initialization of the agent, then this object
contains a zero value.
Row Status
This object is used to delete rows in the
atmSvcVcCrossConnectTable.