Specifications

Manual Modeling Modeling the Modules Connected to the FNB
Device Management Page 151 SmartSwitch 9000/9500 Series
Modeling the Modules
Connected to the FNB
Some modules are modeled in the Topology view
that contains the FDDI LAN, while others are
modeled in the FDDI LAN Topology view (within
the FDDI LAN model). The following modules
must be modeled in a FDDI LAN Topology view:
• 9F120-08
• 9F122-12
• 9F125-08
• 9F241-12
1 In the Topology view, model the modules
listed in the worksheet that are connected to
the FNB as follows:
a Select Edit from the File menu.
b Select New Model By IP... (used for
example) from the Edit menu.
c Enter the Network (IP) Address (from the
work sheet) and the Community String
(optional) for the module you wish to
model. Click OK.
d Click on the model’s icon with the left
mouse button and position the model with
respect to the FDDI LAN icon.
e Repeat steps b through d until all
appropriate modules are modeled at this
level. Click the right mouse button to exit
the edit mode.
2 Double-click the Topology Arrow on the FDDI
LAN to open the FDDI Topology view. Model
the modules listed in the worksheet not
modeled in the Topology view, that are
connected to the FNB as follows:
a In the FDDI Topology view, select Edit
from the File menu.
b Select New Model By IP... (used for
example) from the Edit menu.
c Enter the Network (IP) Address (from the
work sheet) and the Community String
(optional) for the module you wish to
model. Click OK.
d Click on the model’s icon with the left
mouse button and position the model.
e Repeat steps b through d until all
remaining modules are modeled in this
view.
f Position the model icons at the top left
corner of the FDDI LAN Topology view.
g Exit Edit mode.