Specifications

Device Management Page 153 SmartSwitch 9000/9500 Series
Known Anomalies
This section describes any known anomalies affecting Smartswitch 9000/9500 series devices in SPECTRUM.
Table 44: Known Anomalies: Smartswitch 9000/9500 Series Devices
Description Solution
For some SmartSwitch 9000 modules, error messages can
appear when you try to save created entries within the
Static Bridging application’s Static Bridging table.
For example, the 9E133_36, 9E138_36, 9E423_24, and
9F310_02 models display the following:
Update failed for the following attributes:
Attribute 0x1194c - Attribute doesn’t exist on
device,0x200000a
For the Static Bridging table to work, a MacAddr.receiveport
entry must be provided as follows:
1. Click Create Static Database Entry.
2. Confirm the MacAddr.receive value’s existence
3. Click Close and then Save.
This saves the MAC address as a static database entry, and the
error message does not appear.
You may have difficulty creating and removing Permanent
Virtual Circuits (PVCs) and Permanent Virtual Paths (PVPs)
from SmartCell 9A656-04 and 9A686-04 devices.
Use the Virtual Channel views available for your device to create
PVCs, and the Virtual Path views to create PVPs. The creation
procedures are the same. Creating a PVC involves defining
individual links (VPI/VCI) on each of two ports and then cross-
connecting the ports. Use a Virtual Channel Link view to define
the links on each port and then use a Cross Connect view to
cross connect the ports. Before you begin, ensure that you have
write privileges for the device, set the proper traffic parameters
for the ports, and set the ILMI parameters using local
management.