Specifications

Device View Secondary Address Panel
Device Management Page 36 SmartSwitch 9000/9500 Series
UPS Configuration Information View
Access: By double clicking on an entry in the UPS Detail
view.
This view displays information on the condition,
status and the input/output power of a particular
UPS. This view contains the following:
Identification
This section of the UPS Configuration Information
View contains entries that uniquely identify a
particular UPS.
Index
A unique value which identifies a particular UPS.
Name
A name given to a particular UPS.
Model Type
The UPS’s base model type.
Firmware
The UPS’s firmware version.
Serial Number
The UPS’s serial number as set at the factory.
Manufacture Date
The UPS’s date of manufacture, in the format
mm/dd.
Status
The Status section of the UPS Configuration
Information view displays information on the
operational and fault status of a particular UPS.
Operational
The operational status of the UPS. Possible
entries are: on-line, on-battery, overloaded,
low battery, replace battery, smart boost,
sleep, and run time calibration running.
Fault
The fault conditions. The possibilities are:
current, exceeded, malfunction, operation,
and shut down.
Temperature
The UPS’s present internal operating temperature
in degrees Fahrenheit. You can determine the
actual temperature by dividing this value by 10.
Battery Conditions
This section of the UPS Configuration Information
view contains the following information.
Capacity (%)
The UPS’s remaining battery capacity as
expressed by a percent of the fully charged
condition.