Specifications

Device View Secondary Address Panel
Device Management Page 37 SmartSwitch 9000/9500 Series
Voltage
The UPS’s present battery voltage. You can
determine the actual voltage by dividing the value
of the field by 100.
Run Time Remaining (min)
The UPS’s estimated remaining run time (in
minutes). The UPS can be queried when operating
in on-line, bypass, or on-battery modes. The run
time estimate is based on available battery
capacity and output load.
Battery Test
The section of the UPS Configuration Information
view contains information on the last battery test
performed on this UPS.
Initiate Battery Test
Indicates if a battery test has been initiated. Valid
values are: Yes and No.
Test Result
The results of the last battery test performed.
Input/Output Power
This section of the UPS Configuration Information
view contains information on the incoming and
out-going power that the UPS is providing.
Column headings are as follows:
Input Voltage
The UPS’s measured utility input voltage. The
value is determined by dividing the value of the
field by 10.
Output Voltage
The measured UPS output voltage. The value is
determined by dividing the value of the field by
10.
Output Power (Watts)
The UPS’s output load expressed as a percentage
of rated load in watts.
Environmental Module Information
Within the Device Chassis view are the COM 1,
COM 2, and the FNB fields which provide
additional information for the connections on the
Environmental Module. Figure 11 shows the
relationship between the Device view and the
corresponding front panel of the Environmental
Module of the SmartSwitch 9000 chassis.