Specifications

FDDI Repeater Configuration View
Device Management Page 61 SmartSwitch 9000/9500 Series
Link Traps
When enabled, all packets indicating a change in
link status are reported within the trap database.
Valid values are: NoEnable, Enable, or other.
Segmentation Traps
When enabled, all packets indicating a change in
segmentation status are reported within the trap
database. Valid values are: NoEnable, Enable, or
other.
Source Address Traps
When enabled, all packets indicating a change in
source address are reported within the trap
database. Valid values are: NoEnable, Enable, or
other.
Alarm Configuration
This area of the Repeater Configuration view
provides configuration information on generating
alarms for the selected module. The configuration
information is as follows:
Timebase
This field allows you to set the alarm timebase.
The timebase is the number of seconds used as
the interval for performing all of the rate alarm
checks. The minimum is 10 seconds. For
example, if the timebase is 10 seconds, an alarm
will occur only when the specified number of
errors occurs within 10 seconds.
Traffic Alarms
Allows you to turn traffic alarms off and on. Valid
values are: NoEnable or Enable.
Traffic Threshold
The threshold value within the alarm timebase
that, once the number of packets is exceeded,
generates a traffic alarm.
Collision Alarms
Allows you to turn collision alarms off and on.
Valid values are: NoEnable or Enable.
Collision Threshold
The threshold value within the alarm timebase
that, once the number of collisions per good
packet is exceeded, generates a collision alarm.
Broadcast Alarms
Allows you to turn broadcast alarms off and on.
Valid values are: NoEnable or Enable.
Broadcast Threshold
The threshold value within the alarm timebase
that, once the number of broadcasts received is
exceeded, generates a broadcast alarm.
Error Alarms
Allows you to turn error alarms off and on. Valid
values are: NoEnable or Enable.