Specifications

Token Ring Token Ring Station Table View
Device Management Page 84 SmartSwitch 9000/9500 Series
Initiates a read of the threshold settings for the
selected station or the station entered into the
Station field.
Exits the dialog box without applying settings to
the stations or once you have applied all changes
and wish to exit.
Modifying Threshold Settings
To change the threshold settings for one or more
stations, follow these steps:
1 Move the addresses of all the stations to be
modified to the Apply Settings to list. If you
are only modifying the current station, this
step is not necessary. If you wish to modify a
valid station that does not appear in the list,
enter its MAC address into the Station field.
For information on how to move addresses
between lists, refer to the buttons described
earlier in this section.
2 Select the desired settings to be applied to the
current station and all stations in the Apply
Settings to list by clicking on Enable or
Disable for each alarm threshold and typing
a value into each Threshold field.
3 Click Apply.
If the new alarm thresholds cannot be written to
the device due to the device being down, an error
message appears and you should try again later.
Reading Thresholds from a Station
To read the current threshold settings from any
station, follow these steps:
1 Select the station to be read from the
Stations or Apply Settings to list. If you are
reading from the current station, this step is
not necessary. If you wish to modify a valid
station that does not appear in either list,
enter its MAC address into the Station field.
2 Click Read. The threshold settings for the
selected station are read from the device.
Read
Cancel