Installation guide

Printer Configuration Problems
11-8
On the access server, enter the following command. Substitute the number of the printer
port number for 2:
Local> SHOW PORT 2
Port 2: PORT_2 Server: MMS1
Character Size: 8 Input Speed: 9600
Flow Control: XON Output Speed: 9600
Parity: None Signal Control: Disabled
Stop Bits: Dynamic Signal Select: CTS-DSR-RTS-DTR
Access: Remote Local Switch: None
Backwards Switch: None Name: PORT_2
Break: Disabled Session Limit: 4
Forwards Switch: None Type: Hard
Default Protocol: LAT Default Menu: None
Autolink Timer One:10 Two:10 Dialer Script: None
Preferred Service: None
Authorized Groups: 0
(Current) Groups: 0
Enabled Characteristics:
Input Flow Control, Output Flow Control, Signal Check
From this display, read the access server name (in this case, MMS1) and the port name (in
this case, PORT_2). Verify that the access server and port names match what is defined on
the service node.