Installation guide

Remote Login Problems
16-8
If the username is not specified on the command line, the port username is usually the
name used. The following are exceptions to this situation:
• If you have changed your port’s username since logging in, the username used to
authenticate to the access server is the username used by Rlogin. The name given by
SHOW PORT AUTHORIZATION is in the form "name@realm." Rlogin uses the
name from "name@realm."
• If the port username is in the form of "name@realm", then Rlogin only uses the name
portion.
The Rlogin characteristic, username, referred to in this solution is described in more detail
in the Rlogin chapter in the Network Access Software Management Guide.
If the client username is not the same as the server username, use the following command
to connect to the remote system. It is necessary to use quotation marks to preserve
lowercase.
Local> RLOGIN remote-host USERNAME "server-username"