Installation guide

1-3
Software Installation Problems
Verify the Load Host
Consult the following information to ensure that your operating system is compatible with
the software. If your operating system is compatible, perform the tasks listed in Verify the
Software Location and File Name through Verify the Load Host Is Available and Service
Is Enabled.
For UNIX systems:
The following generic operating systems are supported. Complete support cannot be
granted on systems where customization has taken place. In addition, some UNIX
implementations, other than those in the following list, may operate successfully, but no
support is implied.
Operating System/Software Minimum Version Required
DECnet OSI for OpenVMS operating system Version 5.5
Digital UNIX operating system Version 1.0
Microsoft Windows 9x,me,2000 operating system Not applicable
Microsoft Windows NT operating system Version 3.5.1
OpenVMS VAX operating system Version 5.0
If Flash RAM is installed but its boot block is invalid, then the total memory size
will appear as zero.
If your system is equipped with Flash RAM, you can use the INITIALIZE
command to load from either Flash RAM or the load host. If your system is not
equipped with Flash RAM, you can only initialize from the load host. For more
information on initialization, refer to the Network Access Server Management
Guide.
The default INITIALIZE command loads from Flash RAM only if the load image
name displayed with SHOW MEMORY CONFIGURATION matches the software
name shown in the LIST SERVER display.
NOTES