Installation guide

Messages 400 – 499
21-14
Local -487-User Account account-name does not exist
Explanation: A user account with the specified name was not found in the database.
Action: Enter a valid user account name, or contact the system administrator.
Local -488-Insufficient resources to complete security operation
Explanation: The access server could not complete the operation due to memory
problems.
Local -489-Dialback number too long
Explanation: The dial out number string is too long.
Action: Use a shorter string.
Local -490-Dialout number too long
Explanation: The dial out number string is too long.
Action: Use a shorter string.
Local -491-Service name too long
Step Action
1 If every port on your access server is only intended for Telnet use, enter the
following command:
Local> CHANGE SERVER NODE LIMIT 1
This prevents the access server memory from being filled with service node
information.
2 Verify the number of Internet hosts defined locally in the access server’s
operational database. Enter the following command:
Local> SHOW INTERNET HOST LOCAL
If a lot of Internet hosts are defined locally, this might cause memory problems. To
delete locally defined Internet hosts, enter the following command:
Local> CLEAR INTERNET HOST LOCAL
For information on managing your access server as part of the TCP/IP network,
refer to the Network Access Software Management Guide.
3 Verify access server memory usage. See the section Verify Access Server Memory
Usage
(Chapter 2).