Installation guide

Messages 900 – 999
26-8
Ask the system manager to perform the following command. Substitute the DECnet node
name of the access server for server-node-name:
At an OpenVMS load host, enter the following:
NCP> LOOP CIRCUIT server-node-name
The Network Control Program (NCP) shows the results of the loopback test at the DECnet
node.
Local -954- [protocol] Attempting to locate dump host [datalink]
Explanation: The access server has terminated abnormally. It is searching for a host that
will accept an upline dump file.
Action: No user action is required.
Local -955- [protocol] Host address located [datalink]
or
Local -956- [MOP] Requesting load from host address
Explanation: The host system failed to complete the downline load to the access server.
The access server will automatically try to downline load again.
Action: For information on software installation failure, refer to Chapter 1 .
Local -957- [protocol] Requesting dump to host address
Explanation: The access server has terminated abnormally. It has requested an upline
dump to the specified host.
Action: No user action is required.
Local -958- [MOP] Boot request received from address
Explanation: The access server received a valid request from the specified host to initiate
a downline load of the access server software.
Action: No user action is required.
Local -959- [FLASH] Attempting to locate load image [FLASHRAM]
Explanation: The access server is attempting to locate the load image in Flash RAM.
Action: No user action is required.