Installation guide

Telnet Resource Problems
3-12
Telnet Client Editor Characters Not Functioning
Properly
Solution
If you experience unusual responses to keystrokes when using various editors during a
Telnet session, enter the following command. Substitute the number of the port for 1 and
the number of the session for 2:
Local> SHOW PORT 1 SESSION 2 CHARACTERISTICS
Port 1, Session 2, Protocol TELNET
Profile: Character
Echo: Remote Newline From Term: <CR>
Toggle Echo: ^E Newline From Host: <CRLF>
Binary: Duplex Newline To Term: <CRLF>
Xmit Size: 8 Newline To Host: <CRLF>
Rcv Size: 8 Input Flow Control: Disabled
Signal Req.: Disabled Output Flow Control: Disabled
IP: +s +f ^Y Msg. Verification: Enabled
SYNCH: +s -f ^X Switch Characters: Enabled
AYT: -s -f ^T Quote: None
AO: -s +f ^O
EOR: -s -f None
BRK: -s -f None
The port characteristics (Profile, Binary, Signal Req., Input Flow Control, and Output
Flow Control) should be set as indicated above. For more information on configuring
Telnet client session characteristics, refer to the Network Access Software Management
Guide.